Everyday thousands of people are being attacked by a wide variety of Internet threats including Viruses, Worms, Trojans, Spyware and spam.
We provide virus removal services, as well as detection and most importantly prevention for your computers.
This service includes different type of removals. Like Virus Removal, Spyware Removal, Adware Removal, Malware Removal etc.
Some symptoms of being attached by internet virus, spyware
- Frequent crashes followed by restarts after every few minutes.
- Recurrent unusual error messages or distorted menus and dialog boxes.
- Inaccessible disks and disk drives.
- Unexpected strange sounds or music plays from the speakers.
- Non-working of PC applications or sudden disappearance of programs and apps.
- Inability to install or run anti-virus
Has your laptop suddenly started getting very hot, the fan is spinning constantly and it seems to be running slowly? This is caused by blockages of the inner airways, we can dismantle your laptop and clean out the fans, heatsinks and airways returning your laptop to as good as new.
We can now produce and rewind electromagnet solenoids and small transformers.
We are able to produce coils that are upto 6" long and 4" o/d.
We can produce sample coils to your specifications or if you have a coil that is faulty or that you need copying, we are able to pull the windings off and then we can either wind new wire back onto the existing bobbin or we can use the information gathered from the old coil to create a new one.
Pictured below are some coils that we have recently repaired, the 2 plastic bobbins on the left were short circuit, when they were pulled down, 1 had burnt right through the plastic, the wire gauge and number of turns were noted down and a new one was made onto the 1 good remaining bobbin. The large coil in the middle has gone open circuit, this has yet to be taken apart and re-made, the bobbin is made from brass with bakelite ends, so it will just be a case of unwinding and then rewinding new wire back on.
The coils on the right and at the bottom of the photo are just a couple that we have made to show the 'finished' article.